电热水锅炉http://www.jnshengxin.cn/在点火前，先打开循环水泵，然后检查循环水泵流量扬程是否是正常的。要确认水循环、排气等没有问题，且上压至设定值后，才能够点火。将自然通风门打开至一定程度后用一些易燃物引火，比如木柴等，但是不能用具有强烈挥发性的油类引火，这样是非常危险的。
Electric water boiler before ignition, open circulating pump, circulating pump flow head and then check whether it is normal. To confirm the water cycle, exhaust, etc. is no problem, and after the pressure to the set value, it can ignite. After natural ventilation door open to a certain extent with some of the combustible ignition, such as firewood and so on, but can not use the volatile oils have a strong fire, this is very dangerous.
先开启电热水锅炉引风机，然后打开鼓风机，这样能够避免在预热管子时，出现变形或烧坏等现象。电热水锅炉点火好以后，火力应是由弱到强，逐渐加大，等到煤正常着火后，再启动炉排，调整煤闸板的开度，并加大送风量，这样让煤能够完全进行燃烧。
First open the electric hot water boiler fan, and then open the blower, this can be avoided when preheating pipe, deformed or burned and so on. After a good electric water boiler ignition, the fire should be to strong, gradually increasing from weak, normal firing until after the coal, and then start the grate, adjust the opening of the gate of the coal, and increase the air supply, so let coal can be completely combustion.
电热水锅炉http://www.jnshengxin.cn/应按照规定要求，定期进行排污工作，排污工作，应在锅炉压力稳定，且负荷比较低的情况下进行，定期排污时，应按照循环回路顺序进行，每一次的循环排污事件不能超过30秒。排污阀不能同时开启两个或多个以上，以免破坏水循环。
Under electric hot water boiler should be in accordance with the requirements of regular sewage work, sewerage work, should be in the boiler pressure is stable, and relatively low load situations, periodic sewage, shall order the circulation loop, loop sewage every event must not exceed 30 seconds. Drain valve can not open two or more of the above, in order to avoid damage to the water cycle.
